Configure a Captis for the NSW Non-urban Water Monitoring Program

All units will be fully configured and bench-tested before shipping, resulting in a plug and play installation process.

Captis devices must be installed by a certified Captis installer.

Register now to become a Captis certified installer

Please purchase devices from the B2B Portal and register the site on the DQP Portal before completing this form

DQP Name

DQP Phone

DQP Email

Meter ID (Provided in the DQP Portal during site registration)

Name and Model of Meter to connect to

Meter communication protocol

Units of water flow

Pulse Meters

The meter must have passive pulse outputs.

1 Pulse output equals a flow of:

Pulse width (Must be greater than 50ms)I confirm that the pulse width is greater then 50 ms

Modbus Meters

The meter must be in RTU mode.
All the below fields must be provided in order to configure the device for a Modbus connection

Baud rate

Comms Parameters

2 or 4 wire

Meter slave address

Electrical Protocol

Data type of flow

Flow register type

Flow data format

Starting address of flow value

No. of bytes to read the flow

Thank you for submitting your request

Oops! Something went wrong while submitting the form.